Tasmanian devil assembly and gene annotation

Assembly

The mSarHar1.11 assembly was submitted by SC on November 2019. The assembly is on chromosome level, consisting of 445 contigs assembled into 106 scaffolds. From these sequences, 8 chromosomes have been built. The N50 size is the length such that 50% of the assembled genome lies in blocks of the N50 size or longer. The N50 length for the contigs is 62,339,597 while the scaffold N50 is 611,347,268.

Other assemblies

• DEVIL7.0 (Ensembl release 101)

Gene annotation

The gene annotation process was carried out using a combination of protein-to-genome alignments, annotation mapping from a suitable reference species and RNA-seq alignments (where RNA-seq data with appropriate meta data were publicly available). For each candidate gene region, a selection process was applied to choose the most appropriate set of transcripts based on evolutionary distance, experimental evidence for the source data and quality of the alignments.
Small ncRNAs were obtained using a combination of BLAST and Infernal/RNAfold.
Pseudogenes were calculated by looking at genes with a large percentage of non-biological introns (introns of <10bp), where the gene was covered in repeats, or where the gene was single exon and evidence of a functional multi-exon paralog was found elsewhere in the genome.
lincRNAs were generated via RNA-seq data where no evidence of protein homology or protein domains could be found in the transcript.

• Detailed information on the genebuild (PDF)

In accordance with the Fort Lauderdale Agreement, please check the publication status of the genome/assembly before publishing any genome-wide analyses using these data.

Data citation
For use of these resources, please cite: Stammnitz, MR et al. 2022, The evolution of two transmissible cancers in Tasmanian devils (https://www.biorxiv.org/content/10.1101/2022.05.27.493404v1)

More information

General information about this species can be found in Wikipedia.